Drainage Slope: converting degrees to percent grade without the usual mess
The Drainage Slope notes on the side of the carton looked confident.
We write these the way we argue them on the bench: exact factor, one sharp trap, one worked example you can re-check.
The Drainage Slope notes on the side of the carton looked confident. The measuring tools disagreed. That is usually where this conversion bites. Start from percent grade = tan(degrees) × 100, keep units glued to every intermediate number, and only round when the tool or spec actually forces you to.
The factor that settles arguments
This is the relationship our converters use. Screenshot it if you have to — just stop re-deriving it from a half-remembered blog post.
percent grade = tan(degrees) × 100
Write that line once at the top of your notes. Every later arithmetic step should point back to it instead of inventing a friendlier number mid-stream.
The mistake that keeps showing up
Reading a chart meant for a different degrees/percent grade convention (legal vs customary, survey vs international) and pasting it into a drainage slope plan.
Forum shortcuts are fine for napkin estimates. They are not fine when a supplier, inspector, airline, or recipe is going to hold you to the number.
When two people share a diy plan across countries, paste the factor into the shared doc. Do not assume everyone grew up with the same household definitions.
- Write the known value with the unit: ___ degrees.
- Confirm you want percent grade (not a lookalike unit).
- Multiply by the exact factor: percent grade = tan(degrees) × 100.
- Round only at the end to the tool/spec precision.
Worked example
Say you are setting up drainage slope and the plan calls for 4 degrees.
4 degrees using percent grade = tan(degrees) × 100
Apply the factor carefully, then round only to the precision your tool supports.
If you want a second check, invert the conversion and see whether you recover the original quantity within normal rounding. When you do not, you flipped the factor or mixed two definitions of the same named unit.
Quick reference table
| degrees | Calculation | percent grade |
|---|---|---|
| 1 | percent grade = tan(degrees) × 100 | see example |
| 2 | percent grade = tan(degrees) × 100 | see example |
| 5 | percent grade = tan(degrees) × 100 | see example |
| 10 | percent grade = tan(degrees) × 100 | see example |
Use the table for speed once you trust the factor. Do not use it as a substitute for understanding which definition of the unit you are on.
Why the exact number matters
Drainage Slope is unforgiving about silent unit swaps. One clean conversion keeps the shopping list, the machine setting, and the final check talking about the same physical quantity.
Precision is not about showing off decimals. It is about making sure the shopping list, the machine setting, and the acceptance check are all describing the same physical quantity.
Pocket recap
Write percent grade = tan(degrees) × 100 once. Multiply degrees → percent grade in one step. For drainage slope, the last digit only matters when the real-world tolerance says it does.
Keep the converter link nearby for the next time the same debate shows up in a group chat. Re-typing the factor from memory is how the wrong cousin of a unit sneaks back in.
Try the converters mentioned in this article
FAQ
What is the exact degrees to percent grade factor?+
percent grade = tan(degrees) × 100
Can I round early for drainage slope?+
Carry full precision through the multiply, then round the final value to match the measuring tool — early rounding is how small errors become visible defects.
How do I sanity-check the direction?+
Estimate first. If the answer moves the wrong way by an order of magnitude, you flipped degrees and percent grade.
This article was written by The Turbo Unit Converter engineering desk (Applied units & field metrology) and last reviewed on 2026-07-22 against NIST SP 811 and the BIPM SI Brochure. Read our full editorial policy.